AIIR - Brukermanual

https://lh6.googleusercontent.com/GS5PXB8IATmPl2J7NciBybW4RpAAnwVS-5F_BorA4TXKNpGkdtrOkvK-LEODT2StEv2lXEd7JwqS1bXlWNXhvI81JTxwcinuCjWr_YoS8chceU7HlLf7MqslyKWBwsdin2hvJ84h


AIIR-USER MANUAL


https://lh4.googleusercontent.com/NsNcuzKcRCTYUAOOLJJlTWUGml4QoKSaAfSkmJLWuD4hT-moHozxQ7NTNolEjqsa1kAs2ICU32I9e0HhvH-7FCvViSgoUqTW9gle352EVjcRSxQgbmcOcc02kPNTRKCoA8i_QDfB

 

TABLE OF CONTENTS

TABLE OF CONTENTS. 1

1 - INTRODUCTION.. 1

2 - SAFETY FIRST. 2

3 - BASIC INFLATION INSTRUCTIONS. 2

4 - SPECIAL NOTES. 3

5 - DEFLATION AND PACK UP INSTRUCTIONS. 3

6 - TROUBLESHOOTING.. 4

7 - CONTACT. 4

1 - INTRODUCTION


AIIR - For your love and passion for gymnastics and for the quality of your performance

Thank you for purchasing one of our Aiir-products!

Please make sure to read through these safety instructions carefully before using your newly acquired Aiir-product

Please contact us if anything should be unclear.

From Aiir, Happy tumbling...!


2 - SAFETY FIRST

These instructions apply to all inflatable products from Aiir.

These products will be referred to as Aiir-products

Only use your Aiir-product for its intended purpose

Risk of injury can be reduced by strictly following these rules at all time:

  1. Use the mat only on firm ground and completely surrounded by appropriate environment.
  2. Only use the mat under the supervision of trained and qualified instructors.
  3. Ensure that the surface of mat is completely dry and the mat is in good condition before use.
  4. Always check that air the pressure meets minimum requirements, as stated in manual before use.
  5. Check pressure periodically to ensure that it contains the proper pressure. Be aware that external changes of temperature will affect internal pressure of the mat - check pressure when external temperature changes.
  6. Do not leave mat partially inflated in an area where it could be used without supervision.
  7. This mat can move during use. Always check for proper positioning of the product before use

Any activity involving motion, rotation, or height creates the possibility of serious injury or permanent paralysis and even death from landing or falling on the head, the neck, or other vital parts of the body. This mat does not eliminate this hazard entirely. Use the AirTrack on your own risk.

The user should know their personal limitations before use.

In case of uncertainty, consult a trained qualified instructor.

3 - BASIC INFLATION INSTRUCTIONS

  1. Before inflating, pick the right location for the Air Product. You must fully unroll your air product to check the space which must be clean, dry, flat and free of obstacles. If you’re using the Air Product outside, always use a ground cover.
  2. When ready to inflate your Aiir-product please use the correct pump nozzle.
  3. Your Aiir-product will come with one or two valves.
    1. How to OPEN and CLOSE the valve, remove the top cap, then…
    2. [Bilde] To OPEN: Just press the button in the centre of the valve. It should LOCK DOWN, this allows air in and out.
    3. [Bilde] To CLOSE: Just press the button AGAIN( in the centre of the valve). It should POP BACK UP. Keep the valve in this position to the Aiir-product is all inflated .
  4. Make sure the button/pin in the Valve is popped out into the locked position.
  5. Insert the nozzle into the valve and turn clockwise. Your Aiir-product is now ready to be inflated.
  6. Once the Aiir-product has reached the desired pressure, remove the adapter from the valve by twisting the nozzle counter clockwise and refit the caps . Make sure the valve center piece is still in the locked position.
  7. Your air track are ready to use !

4 - SPECIAL NOTES

  • Please note if using your own electric pump please ensure you do not over inflate your aiir-product as this will void your warranty. It is impossible to over-pressurize the air products with the pump we supply.
  • To let pressure out, push down slightly on the grey button to lock it in the OPEN position.
  • Valve should always be in CLOSED position when you are finished with the inflating and refit the top cap before use.
  • If using your own manual pump, we cannot guarantee that you will get enough pressure into your Aiir-product.
  • Recommended air pressure

The optimal air pressure depends largely on the weight and experience of the users.

Body weight

10cm / 4 inch

20cm / 8 inch

30cm / 12 inch

20 - 30kg

70 - 80 mbar

40 - 50 mbar

30 - 40 mbar

30 - 60kg

70 - 100 mbar

50 - 60 mbar

40 - 60 mbar

60 - 90kg

100 - 140 mbar

60 - 70 mbar

60 - 70 mbar

90+ kg

150 mbar

75 mbar

75 mbar

5 - DEFLATION AND PACK UP INSTRUCTIONS

  1. Open all valves to start the deflation. To deflate without a pump, push the button / pin in the center of the valve to to set the valve in OPEN mode. If you have an E-pump with deflation ability, you can be used this to remove the air from your Aiir-product more quickly.
  2. For small size air track ,carefully roll up you Aiir-product from the opposite side of the valves, this allows the air to escape while rolling your air product up. For big size air track ,you should fold the sides towards the middle line and also roll up it from the opposite end of the valves.
  3. Once rolled up,keep the button popped out and close all valves ! This prevents the caps from damaging the valves' screw thread. Use a strap to keep mat roll up tight.
  4. Put the mat into the bag, then pull up the zipper, and your Aiir-product is ready for transport or storage.

6 - TROUBLESHOOTING

If your Aiir-product seems to be leaking and losing air quickly, there is various conditions you can check to find the reason.

TIPS: If the leakage is not easy to find by listening, you can use an ordinary spray bottle and fill it with ordinary dish soap and water. Spray this on valves and seams. If there is a leakage, the soap and water mix will present it with bubbles.

Check the valves. The centre pin of the valves, may easily be left in the always OPEN position. Make sure the valve is closed.

TIPS: Sometimes one of the inside threads can be caught in the valve mechanism. This can be difficult to see with the naked eye, but might be seen inside the valve. This might cause minor leakage.

If a leakage is found along the seam, this can be fixed with high quality PVC glue from your local hardware store. From online stores, the brand “Aquaseal” is a good option.

Unless you have a severe damage to your Aiir-product, you should not worry.
Most leakages are fairly simple to fix, and we will assist you.

7 - CONTACT

If you have any comment or suggestions regarding this manual, please contact us.

AIIR
Bjørn Evjesgate 7
3681 Notodden
Norway

Email:    
post@aiir.no

Web:     
https://www.aiir.no/

https://www.aiir.shop/

 

Trustpilot